Allied Telesis AT-S62 - Manual (Page 470)

Chapter 30: IGMP Snooping Commands
470
SET VLAN
Syntax
set vlan=name|vid port=ports frame=tagged|untagged
Parameters
vlan Specifies the name or VID of the VLAN to be
modified.
ports Specifies the port whose VLAN type is to be
changed. You can specify more than one port at a
time. You can specify the ports individually (for
example, 5, 7, 22), as a range (for example, 18-22), or
both (for example, 1, 5, 14-22).
frame Identifies the new VLAN type for the port. The type
can be tagged or untagged.
Description
This command changes a port’s VLAN type. You can use this command
to change a tagged port to untagged and vice versa.
Before using this command, note the following:
❑ Changing a port in a port-based, tagged, or protected ports VLAN
from untagged to tagged adds the port to the Default_VLAN as
untagged.
❑ Changing a port in the Default_VLAN from untagged to tagged
results in the port being an untagged member of no VLAN.
❑ Changing a port from tagged to untagged removes the port from
its current untagged port assignment.
Examples
The following command changes port 4 in the Sales VLAN from tagged
to untagged:
set vlan=Sales port=4 frame=untagged