Allied Telesis AT-S62 - Manual (Page 253)

AT-S62 Command Line User’s Guide
253
UPLOAD METHOD=TFTP
Syntax
upload method=tftp destfile=filename
server=ipaddress
srcfile|file=switchcfg|filename|appblock
Parameters
method Specifies a TFTP upload.
destfile Specifies a filename for the uploaded file. This is the
name given the file when it is stored on the TFTP server.
If the name contains spaces, enclose it in quotes.
server Specifies the IP address of the network node containing
the TFTP server software.
srcfile or file Specifies the file to be uploaded. Options are:
switchcfg Uploads the switch’s active boot
configuration file.
filename Uploads a file from the switch’s file
system.
appblock Uploads the switch’s active AT-S62
image file.
Description
A TFTP upload uses the TFTP client software on the switch to upload files
from the file system on the system to a TFTP server on the network. You
can use the command to upload a switch’s active boot configuration file
or any other file from the file system, such as an SSL certificate
enrollment request or a public encryption key. The command also allows
you to upload the switch’s active AT-S62 software image from the
application block to a TFTP server, though it is unlikely you would ever
have need for that function.
When performing a TFTP upload, note the following:
❑ A TFTP upload is supported from a local, Telnet, or SSH
management session.
❑ There must be a node on your network that contains the TFTP
server software. The uploaded file will be stored on the server.