Allied Telesis AT-S62 - Manual (Page 276)

Chapter 17: Event Log and Syslog Server Commands
276
syslogformat Specifies the format of the event messages. The
options are:
extended Sends the severity, module, and
description, date, time, and switch’s IP
address for each event. This is the
default.
normal Sends only the severity, module, and
description.
module Specifies the AT-S62 modules whose events are to
be sent to the syslog server. The available options
are:
all Sends events from all modules.
module Sends events from selected module(s).
You can select more than one module by
separating them with commas, for
example, MAC,PACCESS. For a list of
modules, see Table 4 on page 279.
severity Specifies the severity of events to sent from the
switch to the syslog server. Event severity is a
predefined value assigned to an event by the switch,
according to its impact on the switch’s operation.
The options are:
all Sends events of all severity levels.
severity Sends events of a particular severity
level. Choices are I for Informational, E
for Error, W for Warning, and D for
Debug. You can select more than one
severity at a time, for example E,W. For
a definition of the severity levels, see
Table 5 on page 281.
Description
This command modifies an existing syslog server definition created with
CREATE LOG OUTPUT on page 262.
For information on the FACILITY parameter, refer to CREATE LOG
OUTPUT on page 262. For information on the MODULE and SEVERITY
parameters, refer to ADD LOG OUTPUT on page 259.