Allied Telesis AT-S62 - Manual (Page 283)

AT-S62 Command Line User’s Guide
283
SHOW LOG OUTPUT
Syntax
show log output[=id_number] [full]
Parameters
output Specifies the ID number of the event log or a syslog
server definition. If an output ID number is not
specified, all output definitions currently configured
on the switch are displayed.
full Displays the details of the syslog server definition. If
not specified, only a summary is displayed.
Description
This command displays output definition details.
Entering the command without specifying an ID number of an output
definition lists the event log and the syslog server definitions on the
switch. Here is an example:
OutputID Type Status Details
-----------------------------------------------
1
Temporary Enabled Wrap on Full
2 Syslog Enabled 149.44.44.44
4 Syslog Enabled 149.44.44.55
The event log has the ID number 1 and the Type of Temporary, referring
to temporary memory, which is where the event log is stored.
Specifying “1” as the ID number along with the FULL option displays
information about the event log. Here is an example:
Output ID .................... 1
Output Type .................. Temporary
Status ....................... Enabled
Log Full Action .............. Wrap on Full
Event Severity ............... All
Event Module ................. All
Entering the ID number of a syslog server definition along with the FULL
option displays information about the definition. Here is an example:
Output ID .................... 2
Output Type .................. Syslog
Status ....................... Enabled
Server IP Address ............ 149.44.44.44
Message Format ............... Extended
Facility Level ............... DEFAULT
Event Severity ............... All
Event Module ................. All