Allied Telesis AT-S62 - Manual (Page 90)

Chapter 6: SNMPv1 and SNMPv2 Community Strings and Trap Commands
90
DISABLE SNMP AUTHENTICATETRAP
Syntax
disable snmp authenticatetrap|authenticate_trap
Parameters
None.
Description
This command stops the switch from sending authentication failure
traps to trap receivers. However, the switch will continue to send other
system traps, such as alarm traps. The default setting for sending
authentication failure traps is enabled.
The AUTHENTICATETRAP and AUTHENTICATE_TRAP keywords are
equivalent.
To activate the authentication failure trap, refer to ENABLE SNMP
AUTHENTICATETRAP on page 93
Example
The following command instructs the switch not to send authentication
failure traps to SNMP trap receivers:
disable snmp authenticatetrap