Allied Telesis AT-S62 - Manual (Page 65)

AT-S62 Command Line User’s Guide
65
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. If neither is activated, the status will be
“disabled.” The default setting is disabled.
To enable the DHCP and BOOTP client software, refer to ENABLE BOOTP
on page 41, ENABLE DHCP on page 42, or ENABLE IP REMOTEASSIGN on
page 43. To disable the client software, refer to DISABLE DHCPBOOTP on
page 38 or DISABLE IP REMOTEASSIGN on page 39.
Example
The following command displays the status of the DHCP and BOOTP
client software:
show dhcpbootp