Enable log output – Allied Telesis AT-S62 User Manual

Page 270

Text mode
Original mode

Chapter 17: Event Log and Syslog Server Commands

270

ENABLE LOG OUTPUT

Syntax

enable log output[=id_number]

Parameters

output

Specifies the ID number of the syslog server
definition you want to enable. The range is 2 to 20.
You can specify only one ID number at a time.
Omitting an ID number enables all syslog server
definitions.

Description

This command enables the specified syslog server definition that was
disabled using DISABLE LOG OUTPUT on page 268. When a syslog server
definition is enabled, the switch immediately begins to send events to
the server.

Examples

The following command enables syslog server definition 4:

enable log output=4

The following command activates all syslog server definitions:

enable log output