Allied Telesis AT-S101 - Manual (Page 96)

Chapter 7: LACP Port Trunks
96
Selecting Port Priority
To select port priority, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select the Trunk Config. folder.
The Trunk Config. folder expands.
3. From the Trunk Config. folder, select Port Priority.
The Port Priority Page is displayed. See Figure 30.
Figure 30. Port Priority Page
The System Priority is a preassigned value that you cannot alter. This
value applies to the switch. See “LACP System Priority” on page 90.
The System ID is a MAC address value assigned to the switch. You
cannot change this value.