Allied Telesis AT-S101 - Manual (Page 121)

AT-S101 Management Software User’s Guide
121
Setting Bandwidth Control
This procedure explains how to set DLF, broadcast, multicast, and
threshold levels for each port on the AT-GS950/8POE switch.
To change the default settings, perform the following procedure:
1. From the menu on the left side of the page, select the Bridge folder.
The Bridge folder expands to display several folders including the
Trunk Config. folder.
2. From the Trunk Config. folder, select Bandwidth Control.
The Bandwidth Control Page is shown in Figure 37.
Figure 37. Bandwidth Control Page
3. To enable or disable the DLF field, select Enable or Disable from the
DLF pull-down menu next to the port that you want to change. Then
click Apply.
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
4. To enable or disable ingress and egress Broadcast packets, select
Enable or Disable from the Broadcast pull-down menu next to the port
that you want to change. Then click Apply.