Allied Telesis AT-S101 - Manual (Page 94)

Chapter 7: LACP Port Trunks
94
Displaying LACP Group Status
To display the LACP Group Status, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select the Trunk Config. folder.
The Trunk Config. folder expands.
3. From the Trunk Config. folder, select LACP Group Status.
The LACP Group Status Page is displayed. See Figure 28 for an
example of the default display.
Figure 28. LACP Group Status Page
Note
You cannot change the parameters on this page:
The System Priority is a preassigned value that you cannot alter. This
value applies to the switch. See “LACP System Priority” on page 90.