Allied Telesis AT-S101 - Manual (Page 50)

Chapter 3: Virtual LANs
50
Displaying Ports and Assigning Ports to a VLAN
By default, all of the ports on the switch are assigned to the Tagged VLAN.
The procedure described in this section allows you to display the current
VLAN assignment of ports. In addition, it permits you to assign ports to
tagged or a port-based VLAN. However, you can assign ports to a port-
based VLAN only after you have created a port-based VLAN with the
procedure described in “Creating a Port-Based VLAN” on page 56.
To assign ports to a tagged or port-based VLAN, perform the following
procedure:
1. From the menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select VLAN Mode.
The VLAN Mode Page is shown in Figure 15.
Figure 15. VLAN Mode Page
4. To add ports to a Tagged or Port-Based VLAN, select the ports and
then click Apply.