Allied Telesis AT-S101 - Manual (Page 111)

AT-S101 Management Software User’s Guide
111
Modifying Traps
To modify the SNMP version, IP address, or community name of a trap,
perform the following procedure:
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Setting.
The Trap Setting Page is shown in Figure 33 on page 110.
3. Within the Trap Setting table, select a pull-down menu in the Version
column to the change the SNMP version of a trap that you want to
modify.
Select the SNMP version of the trap by selecting V1 for SNMP version
1 or V2c for SNMP version 2vc.
4. Change an IP address by typing in the new IP address for a particular
community within the Trap Setting table.
Use the IP address format: xxx.xxx.xxx.xxx
5. Change the Community Name by replacing the old name with the new
one.
6. To activate your changes on the switch click Apply.
The Trap Setting Page is updated.
7. From the menu on the left side of the page, select Save Configuration
to Flash to save your changes.