Allied Telesis AT-S101 - Manual (Page 201)

AT-S101 Management Software User’s Guide
201
Creating an In-profile Action
The In-profile Action Page allows you to assign an action to a policy. For
more information about these parameters, see “ACP Components” on
page 197.
To create an In-profile action, perform the following procedure:
1. From the menu on the left side of the page, select the Access Control
Configuration folder.
The Access Control Configuration folder expands.
2. From the Access Control Configuration folder, select In-Profile
Action.
The Create In-Profile Action Page is displayed. See Figure 60.
Figure 60. Create In-Profile Action Page
3. Enter a classifier index between 1 and 65535 in the Index field.
For more information about the classifier index, see “Creating
Classifiers” on page 192.
4. To permit or deny the profile, use the pull-down menu next to the
Deny/Permit field.
Choose either Permit or Deny. The default value is Permit.
5. To set an profile action ID, enter a value between 1 and 72 in the
Profile Action ID field that was configured on the Create Profile Page.
See “Creating Profile Action” on page 199.