Allied Telesis AT-S101 - Manual (Page 31)

AT-S101 Management Software User’s Guide
31
Configuring System Administration Information
This section explains how to enable password protection and create users
in the web interface. See the following sections:
ˆ “Adding System Administration Information” on page 31
ˆ “Modifying Administration Information” on page 32
ˆ “Deleting Administration Information” on page 33
Adding System
Administration
Information
To set a switch’s administration information, perform the following
procedure:
1. From the menu on the left side of the page, click the System folder.
The System folder expands.
2. From the System folder, select Administration.
The Administration Page is shown in Figure 8.
Figure 8. Administration Page
3. To enable or disable password protection, select Enable or Disable
from the pull-down menu next to the Password Protection field. Then
click Apply.
You can control login authentication by enabling password protection
which requires a user to supply a password when logging onto the
switch. If you disable password protection, a user can login without
inputting a password. By default, this field is set to Enable.