Allied Telesis AT-S101 - Manual (Page 116)

Chapter 9: IGMP Snooping
116
Configuring IGMP Snooping
This procedure explains how to set IGMP snooping on the switch and set
the IGMP Snooping age-out timer.
To configure IGMP snooping, perform the following procedure:
1. From the menu on the left side of the page, select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select IGMP Snooping.
The IGMP Snooping Page is shown in Figure 34.
Figure 34. IGMP Snooping Page
3. To enable or disable IGMP Snooping on the switch, select Enable or
Disable. Then press Apply.
By default, IGMP is disabled.
4. To set the age-out timer, type the number of seconds you want the
switch to wait before it purges an inactive dynamic MAC address.
Then press Apply.
The Set Age-Out Timer field is set to 280 seconds by default. The
range of this parameter is between 280 to 420 seconds.