Allied Telesis AT-S101 - Manual (Page 112)

Chapter 8: Simple Network Management Protocol (SNMP)
112
Deleting Traps
To delete a trap from an SNMP community, perform the following
procedure:
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Setting.
The Trap Setting Page is shown in Figure 33 on page 110.
3. In the Trap table, click delete next to the trap you want to delete from
the table.
The trap is removed from the Trap Setting Page. A warning message
is not displayed.
4. From the menu on the left side of the page, select Save
Configuration to Flash to save your changes.