Allied Telesis AT-S101 - Manual (Page 106)

Chapter 8: Simple Network Management Protocol (SNMP)
106
Deleting an SNMP Community
Use the following procedure to delete an existing SNMP community in the
Community Table.
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table page is shown in Figure 31 on page 104.
3. To delete a community, select delete in the Community Table next to
the community that you want to remove.
The Community Table Page is updated.
4. From the menu on the left side of the page, select Save
Configuration to Flash to save your changes.