Allied Telesis AT-S101 - Manual (Page 122)

Chapter 10: Bandwidth Control
122
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
5. To enable or disable ingress and egress Multicast packets, select
Enable or Disable from the Multicast pull-down menu next to the port
that you want to change. Then click Apply.
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
6. To set the Threshold field, use the pull-down menu next to the port
that you want to change. Select Low, Medium, or High which
correspond to the following values:
Low - Specifies 450 to 550 packets per second.
Medium - Specifies 880 to 1,000 packets per second.
High - Specifies 2,200 to 2,500 packets per second.
The default is Low. You can use the option next to the ALL row to set
all of the ports to the same setting.
7. Then click Apply.
8. From the menu on the left side of the page, select Save
Configuration to Flash to save your changes.