Allied Telesis AT-S101 - Manual (Page 203)

AT-S101 Management Software User’s Guide
203
Creating an Out-Profile Action
The Out-profile Action Page allows you to assign a classifier index to a
profile action ID as well as a committed rate and a burst size. For
information about how to create a profile action ID, see “Creating Profile
Action” on page 199.
To create an Out-profile action, perform the following procedure:
1. From the menu on the left side of the page, select the Access Control
Configuration folder.
The Access Control Configuration folder expands.
2. From the Access Control Configuration folder, select Out-Profile
Action.
The Create Out-Profile Action Page is displayed. See Figure 61.
Figure 61. Create Out-Profile Action Page
3. Enter a classifier index between 1 and 65535 in the Index field.
For more information about the classifier index, see “Creating
Classifiers” on page 192.
4. To permit or deny the profile, use the pull-down menu next to the
Deny/Permit field.
Choose either Permit or Deny. The default value is Permit.