Allied Telesis AT-S101 User Manual
Page 23
AT-S101 Management Software User’s Guide
23
3. Change the IP configuration parameters by entering new information in
the following fields:
System MAC Address
This parameter displays the MAC address of the switch. You cannot
change this parameter.
System IP Address
Displays the current IP address of the switch. To change the IP
address, enter a new IP address.
System Subnet Mask
Displays the current subnet mask of the switch. To change the subnet
mask, enter a new subnet mask.
System Default Gateway
Displays the default gateway of the switch. To change the default
gateway, enter a new gateway.
DHCP Mode
For information about setting this parameter, refer to “Enabling and
Disabling the DHCP Client” on page 27.
4. Click Apply.
Note
Changing the IP address ends your management session. To
resume managing the device, enter the new IP address of the switch
in the web browser’s URL field, as shown in Figure 1 on page 14.
5. After you log on to the switch with the new IP address, select Save
Configuration to Flash to save the new IP address to memory.
Caution
If you do not select Save Configuration to Flash, the IP address
may revert to its default setting when you power cycle the switch.