Allied Telesis AT-S101 - Manual (Page 131)

AT-S101 Management Software User’s Guide
131
Modifying a Static Multicast Address
To modify the port assignment of a multicast MAC address in the MAC
address table, perform the following procedure:
1. From the menu on the left side of the page, select the Bridge folder.
The Bridge folder expands to display several folders including the
Trunk Config. folder.
2. From the Trunk Config. folder, select Static Multicast.
The Static Multicast Address Table Page is displayed. See Figure 39
on page 129.
3. Select modify next to the static MAC address that you want to modify.
The Modify Static Multicast Address Page is displayed. See Figure 40.
Figure 40. Modify Static Multicast Address Page
4. In the Group Member row, select the ports that you want to include in
the group MAC address.
Selected ports are indicated with a check mark. Each port has a
maximum limit of 32 static multicast addresses.
5. Then click Apply to apply your changes.
Note
To restore the original group member ports, click Restore.
6. From the menu on the left side of the page, select Save Configuration
to Flash to save your changes.