Allied Telesis AT-S101 - Manual (Page 105)

AT-S101 Management Software User’s Guide
105
Modifying an SNMP Community
Use the following procedure to modify the access level or a community
name of an SNMP community in the Community Table.
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table Page is shown in Figure 31 on page 104.
3. To change the access level of an SNMP community, select the pull-
down menu under the Access column in the Community table for the
community you want to modify.
4. Select Read-Only access or Read-Write access.
5. To change the community name, type over an existing community
name. Then click Apply.
Note
You cannot change the index number of an SNMP community.
6. From the menu on the left side of the page, select Save Configuration
to Flash to save your changes.