Allied Telesis AT-S101 - Manual (Page 22)

Chapter 2: Basic Switch Parameters
22
Configuring an IP Address, Subnet Mask and Gateway Address
This procedure explains how to change the IP address, subnet mask, and
gateway address to the switch. Before performing the procedure, note the
following:
ˆ A gateway address is only required if you want to remotely manage
the device from a management station that is separated from the
switch by a router.
ˆ To configure the switch to automatically obtain its IP configuration from
a DHCP server on your network, go to “Enabling and Disabling the
DHCP Client” on page 27.
To change the switch’s IP configuration, perform the following procedure:
1. From the menu on the left side of the page, click the System folder.
The System folder expands.
2. From the System folder, select IP Setup.
The IP Setup Page is shown in Figure 5.
Figure 5. IP Setup Page