Allied Telesis AT-S101 - Manual (Page 24)

Chapter 2: Basic Switch Parameters
24
Setting Up the IP Access List
The IP Access List feature, when enabled, restricts remote access to
management software by means of a user-configured list of IP addresses.
It does not restrict the management ping response activity, only web
access to the management software.
Note
By default, the IP Access List feature is disabled.
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
ˆ “Creating an IP Access List” on page 24
ˆ “Deleting an IP Address” on page 26
Note
You cannot modify an existing IP address.
Creating an IP
Access List
To create a list of restricted IP addresses, perform the following
procedure:
1. From the menu on the left side of the page, click the System folder.
The System folder expands.
2. From the System folder, select IP Access List.
The IP Access List Page is shown in Figure 6.
Figure 6. IP Access List Page