Allied Telesis AT-S101 User Manual
Page 73
AT-S101 Management Software User’s Guide
73
Displaying and Configuring Ports Using the Port Configuration Page
This procedure explains how to configure the ports on the switch using the
Port Configuration Page. This page allows you to view and configure the
parameter settings of all the switch ports at one time.
To configure the ports, perform the following procedure:
1. From the menu on the left side of the page, select Physical Interface
which is located underneath the System folder.
The Physical Interface Page is shown in Figure 23. The page lists all
the ports on the switch and their current settings.
Figure 23. Physical Interface Page
2. Adjust the port settings as needed. Not all parameters are adjustable.
The parameters are defined here:
Port Index
Specifies the port number. The All value indicates ports 1 through 8.
You cannot change this parameter.
Note
You can use the All value to set the Admin. Status, Mode, Jumbo,
and Flow Ctrl fields to the same values on all eight ports.
Trunk
Indicates the trunk group number. A number in this column indicates