HP LaserJet 3150 All-in-One Printer series - Manual (Page 173)

EN Resolving control panel error messages 171
No Memory for
Report
Erase/Print
Document Memory needed to print a report may be
being used to store faxes that have been
received to memory.
Needed memory may be being used to
store faxes set up to be sent at a future
time or to be polled.
Print faxes that have been received to
memory (see “Printing faxes received to
memory” on page 35).
If you have several faxes set up to be
sent at a future time or to be polled, try
clearing these faxes using Job Status
(see “Canceling a fax job using Job
Status” on page 33).
No Modem Installed The product cannot detect its internal
modem. Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Plug the product to a different power
source.
No Room in Fax Log The fax log was unable to print due to an
error, such as the product is out of paper. Fix the error condition so the product
can print the log.
Not Enough Memory There is not enough memory to complete
the job indicated. Try resending the job. If the error
persists, press and hold
S TOP /C LEAR for
seven seconds to reset the product.
Not Enough Memory
to Duplicate for
COPY The HP LaserJet 3150 product does not
have enough memory to complete the
copy job. Divide the copy job into smaller sections
and then try copying again.
Use the Document Assistant to do the
copy job.
Nov-22-93 06:30 PM
(An incorrect date
appears.) The battery inside the HP LaserJet 3150
product has failed, causing all Menu
features to revert to the factory settings.
Settings that contained alphabetic and
numeric characters you entered, such as
header information and speed-dial names
and numbers, have been erased. You can continue to use the
HP LaserJet 3150 product without the
battery, but any information you enter
will be erased again if power is lost.
The product must be serviced. To
contact HP’s customer care center, see
the front of this manual.
Paper Bin is Empty
Please Add Paper The paper input bin is empty. Load paper. If paper is already loaded,
remove it. Check for and remove any
jammed paper and then reload the
paper stack in the paper input bin.
Password must be 4
Digits Attempt was made to enter a password
that was not 4 digits. Re-enter 4-digit password.
Message Cause Solution