HP LaserJet 3150 All-in-One Printer series - Manual (Page 136)

134 7 Managing Basic Features EN
Turning on or off error correction
Normally, the HP LaserJet 3150 product monitors the signals on the
telephone line while it is sending a fax, which it sends in pieces. If the
HP LaserJet 3150 product detects an error signal while it is sending a
piece of the fax, it can resend that piece.
The factory default for this setting is On. Only change it to Off if you
are having trouble sending or receiving a fax and want to accept the
errors in the transmission. Turning the setting off might be useful
when you are trying to send a fax overseas or using a satellite
telephone connection.
To turn on or off error correction
1 Press E NTER /M ENU .
2 Use the < and > keys to select FAX SETTINGS and press
E NTER /M ENU .
3 Use the < and > keys to select ALL FAXES and press
E NTER /M ENU .
4 Press E NTER /M ENU to select ERROR CORRECTION .
5 Use the < and > keys to select ON or OFF and press E NTER /M ENU .
6 Press S TOP /C LEAR to exit the Menu settings.
7 After sending the fax, repeat steps 1-6 to return the setting to ON .
Hint Instead of changing this setting, you can turn off error correction only
for certain numbers. To do so, you must have special dialing symbols
enabled (see “Enabling special dialing symbols” on page 108).
Then, when dialing a fax number that needs error correction turned off,
press
* , use the < and > keys to select ERROR CORRECTION , and press
E NTER /M ENU . Press > to select YES and press E NTER /M ENU . An E
appears on the control panel display. Finish dialing the number, and
then load and send the fax. Error correction is off only for this job.
You could also enter this symbol in any number you assign to a one-
touch key or speed-dial code. Error correction turns off every time you
use this one-touch key or speed-dial code and then turns back on again.
If the one-touch key or speed-dial code also appears in a group-dial
code, error correction is turned off just for that member of the group.