HP LaserJet 3150 All-in-One Printer series - Manual (Page 153)

EN Adjusting general defaults 151
Changing the default resolution
Resolution affects the quality, in dots per inch (dpi), of your fax or copy
documents. It also affects the transmission speed of faxes. Use this
procedure to change the default resolution, which is the resolution
normally used. The choices for this setting are Standard (the factory
default), Fine, Superfine, or Photo. If you choose Superfine or Photo,
faxes are not scanned before the fax number dials and connects. This
means the document feeder tray will be unavailable until the fax
number connects.
Outgoing faxes are transmitted using whichever of the four choices
you select. Copies are made always using Superfine and won’t be
affected by this setting unless you choose Photo. For more
information about resolution choices, see “Resolution options” on
page 22.
Note If you only want to change the resolution for the fax or copy job you are
currently sending, see “Adjusting the resolution” on page 21 or chapter
4, "Copying."
To change the default resolution
1 Press E NTER /M ENU .
2 Use the < and > keys to select USER DEFAULTS and press
E NTER /M ENU .
3 Use the < and > keys to select DEFAULT RESOLUTION and press
E NTER /M ENU .
4 Use the < and > keys to select the default resolution you want.
You can choose STANDARD (the default), FINE , SUPERFINE , or
PHOTO .
5 Press E NTER /M ENU to save your selection.
6 Press S TOP /C LEAR to exit the Menu settings.