HP NonStop G-Series - Manual (Page 96)

ATM Line
The Asynchronous Transfer Mode (ATM) line represents the logical link between the ATM CRU and the ATM network.
There is one ATM line per
ATM CRU .
Location in OSM Tree: System > Group > Module > ATM3SA > Line
Example: Line $ATM (1.1.54)
Attributes
Line $ATM
Displayed in the Attributes tab and Attributes dialog box only if the value is something other than
OK.
Values
Service State
Logical
The maximum number of virtual path connections (VPCs).
Value: 0 through 256 Maximum Number of VPCs
The maximum number of virtual channel connections (VCCs).
Value: 0 through 3072 Maximum Number of VCCs
The address that is specified for this ATM Line. ATM Address Configured
The User-Network interface (UNI) management entity virtual path identifier (VPI).
Value: 0 through 255 UNI Management Entity VPI
The maximum number of Virtual Circuit IDs (VCIs) that can be active for permanent virtual
circuits.
Value: 32 through 3072 Maximum Number of VCIs
The version of the User-Network Interface (UNI) supported by this ATM line. UNI Version
The maximum number of virtual path identifiers (VPIs) for permanent virtual circuits.
Value: 0 through 256 Maximum Number of VPIs
The address that is registered for this ATM Line. ATM Address Registered
The state of the component as known to the operating system on the server. Values Device State
The address width and the maximum number of Virtual Circuit ID (VCI) bits that can be
active.
Value: 0 through 16 Maximum Number of VCI Bits
The User-Network interface (UNI) management entity virtual circuit identifier (VCI).
Value: 0 through 3071 UNI Management Entity VCI
The address width and the maximum number of Virtual Path ID (VPI) bits that can be active.
Value: 0 through 8 Maximum Number of VPI Bits
Actions
None.
96 System Resources