Attributes, Physical, Actions – HP NonStop G-Series User Manual
Page 214: Link to web interface, Rediscover, Stop monitoring, Ups physical, Link to web interface rediscover stop monitoring
UPS
Uninterruptible power supply (UPS) unit that provides backup power for IOAM enclosures.
NOTE:
OSM supports SNMP card versions up to and including v3.20.
Location in OSM Tree: System > Monitored Service LAN Devices > UPS
Example: UPS SDUPS
Attributes
UPS
Displayed in the Attributes tab and Attributes dialog box only if the value is something other than
OK.
Service State
Physical
Indicates the current status of the UPS battery. Possible values are Normal and On Battery.
OSM displays a yellow alarm if the UPS goes On Battery (or starts drawing power from the battery).
This alarm goes away when the UPS stops drawing power from the battery. OSM displays a red
alarm when the battery power is low.
Battery Status
Indicates whether the UPS is up or down.
Device Status
Version of the firmware on the UPS SNMP card.
Firmware Version
Displays additional information about the UPS as set by super-user in the web interface (see the
action). Up to 20 characters are allowed.
Example: UPS Web Card
Identificaton Information
The IP address of the UPS.
IP Address
The unique number assigned to the UPS in manufacturing. Knowing the serial number is especially
helpful when you need to replace batteries or required other service.
Example: TU321A1185
Serial Number
Displays the version of the UPS software.
Software Version
Displays the UPS model version.
Example: R5500 XR
Type
Displays the physical location of the UPS as set by the super-user in the
action.
UPS Location
This is the apparent power rating of the UPS, expressed in Volt-Amperes.
Example: 12000 VA
VA Rating
Actions
Link to Web Interface
Launches a browser-based configuration interface for the UPS, which provides additional information and configuration
options for the UPS.
Rediscover
Causes OSM to refresh and reanalyze the object. Refresh refers to OSM updating the attribute values displayed in
the OSM Service Connection interface. Reanalyze refers to the running of OSM incident analysis, which checks EMS
event messages and creates alarms in OSM if certain conditions exist.
Stop Monitoring
Stops OSM from monitoring the UPS.
214
System Resources