Actions, Abort, Firmware update – HP NonStop G-Series User Manual
Page 95: Responsive test, Start, Test verify
The name of the file to be used for a firmware update.
Default Firmware Filename
The version of the firmware to be used for a firmware update.
Default Firmware File Version
Indication of the differences, if any, between the current and default firmware versions.
Compare State
Actions
Abort
Terminates operation of the ATM CRU and the associated ATM line. When the Abort action finishes, the ATM CRU
and the ATM line are in the Stopped state.
Firmware Update
Updates the ATM adapter firmware.
Responsive Test
Verifies that the component is connected and responding.
Start
Starts the ATM CRU and the associated ATM line. The ATM CRU must be in the Stopped state before you perform
this action.
During startup, the controller operational code is automatically loaded into the ATM CRU. When the Start action
finishes, the ATM CRU and the ATM line are in the Started state.
Test Verify
Runs all the firmware diagnostic tests on the CRU. This test takes about three minutes to finish. The CRU must be in
the Stopped state before you initiate the Test Verify action.
ATM3SA (ATM Adapter)
95