HP NonStop G-Series - Manual (Page 208)

Set Data Collection Volume
Used to specify a volume in which automatic or manual data collection will take place. The volume should be something
other than $SYSTEM to avoid the possibility of filling that volume with collected data.
The Diagnostic Data Collection Volume attribute displays the currently specified volume. How long the files are retained
in this volume before being automatically deleted is determined by the Set Days to Persist for Diagnostic Data action.
This value is displayed by the Days to Persist Collected Diagnostic Data attribute.
Set Days to Persist for Diagnostic Data
Determines how many days the collected hardware failure data is retained on the system before being deleted. Any
PAK or LOG file older than this value is deleted the next time automatic or manual data collection is initiated.
Suppress Problem Incident Report Creation
This action, which can be initiated by a user or guided procedure, suppresses the creation of Problem Incident Reports
for the default time of 40 minutes. The default value can be changed in the OSMCONF file or extended for an action
currently in progress by using the
Extend Problem Incident Report Suppression Time action. Performing this action
while the system is already in the suppressed state resets the duration of the current suppression to the default time.
Unsuppress Problem Incident Report Creation
Removes suppression caused by the Suppress Problem Incident Report Creation action. While this suppression is
automatically unsuppressed when the specified suppression time has been reached, you can choose to end the
suppression immediately using this action.
208 System Resources