HP NonStop G-Series - Manual (Page 192)

SSAC (SCSI SAC)
The SCSI SAC (ServerNet addressable controller) is a SCSI plug-in card mounted on these devices:
•
Processor multifunction 2 ( PMF2 ) CRU (external SCSI controller, SAC 3)
•
I/O multifunction ( IOMF2 ) 2 CRU (external SCSI controller, SAC 3)
•
ServerNet/DA CRU (There can be up to four SCSI SACs on each ServerNet/DA CRU.)
SCSI SACs are used for connecting external SCSI devices such as tape drives.
Location in OSM Tree: System > Group > Module > IOMF2 > SSAC
Example: SSAC (1.1.50.3)
Attributes
SSAC
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Values
Service State
Physical
The type of CRU this SAC is connected to.
values: SSAC, FSAC, SCSI Type
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts. Part Number
A unique serial number that identifies the component. Track IDs are used for tracking
components. Track ID
A code that identifies the generation of the component. Hardware revision codes are
used for tracking components. Hardware Revision
Logical
The type of device supported by this SAC.
Values: Disk, Tape, SCSI Controller, Not Configured, Unknown Configured Type
Actions
Responsive Test
Verifies that the component is connected and responding.
192 System Resources