HP NonStop G-Series - Manual (Page 207)

Incident Report Configuration
Indicates whether or not OSM's ability to create Problem Incident Reports has been
suppressed. This suppression is accomplished by the
Suppress Problem Incident
Report Creation action and is desirable to stop dial-out of known problems, such as
those that may occur during CRU replacements.
Values: Suppressed, Unsuppressed
Problem Incident Report Creation State
Why the creation ability was suppressed, displayed as free form text.
This attribute is shown only if the Problem Incident Report Creation State value is
Suppressed. Reason for Suppression
The date and time the creation ability was suppressed.
This attribute is shown only if the Problem Incident Report Creation State value is
Suppressed. Time of Suppression
How long the suppression will last (in minutes). The default value is 40 minutes. You
can extend he time using the
Extend Problem Incident Report Suppression Time
action.
This attribute is shown only if the Problem Incident Report Creation State value is
Suppressed.
Duration of Suppression
Actions
Add Node to ServerNet Cluster
Launches a guided procedure that adds the local system to a ServerNet Cluster. This procedure is also used to
configure or display information for Expand-over-ServerNet line handlers.
Collect Diagnostic Data
This action collects diagnostic data for your system. Upon performing the action, you are prompted to specify date
and time parameters. Based on the date and time specified:
•
Diagnostic events are collected for a period of 12 hours (configurable through OSMCONF file) before and three
hours after the specified date and time.
•
Diagnostic Data files, such as ZZAAxxxx, ZZSNxxxx, and ZZPSxxxx, are collected for a period of three hours
starting from the specified date and time.
The volume in which this diagnostic data is collected is specified by the Set Data Collection Volume action.
Disable Advanced Storage Configuration
Disables the system's Advanced Storage Configuration State attribute. In the disabled state, no advanced storage
configuration changes, such as Flexible Disk Configuration or configuration of ESS disks, can be made on the system.
Enable Advanced Storage Configuration
This action changes the system's Advanced Storage Configuration State attribute to Enabled. This state must be
enabled before you can configure ESS disks in SCF or perform Flexible Disk Configuration.
Enable/Disable Automatic Data Collection
Use to enable or disable automatic collection of data for failed system resources. The current state for the system is
indicated by the
Automatic Data Collection State attribute. If enabled, when a hardware failure occurs, data is saved
to the location specified by the Set Data Collection Volume action. The Set Days to Persist for Diagnostic Data action
determines how long the files are retained on the system before being deleted.
Extend Problem Incident Report Suppression Time
Extends the duration of suppression by a specified amount of time (in minutes). This action fails if the suppression
was not enabled at that time.
Rediscover System
Causes OSM to refresh and reanalyze all components within the system.
Rediscover System and ServerNet Cluster
Causes OSM to refresh and reanalyze all components within the system and the ServerNet cluster.
System 207