HP NonStop G-Series - Manual (Page 128)

FCSA
Fibre Channel ServerNet adapter. The FCSA object always displays two FCSA FSAC s, regardless of whether they
are both physically present. At least one must be present to perform FCSA firmware updates. The FCSA FSAC
attributes
Node Name and Port Name indicate the presence of FCSA FSACs and attached disks. Unlike many other
adapters, the ports on the FCSA are numbered from top down when viewing the FCSA installed in a rack. Thus, FCSA
FSAC 1 is attached to the upper port (port 1) and FCSA FSAC 2 is attached to the lower port (port 2).
NOTE: If a ServerNet switch board is not present, FCSAs do not appear in OSM.
OSM does not display FCSA attribute information until an associated disk process is configured and started. For more
information, see the Fibre Channel ServerNet Adapter Installation and Support Guide.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > FCSA
Example: FCSA (13.3.1)
Attributes
FCSA
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Values
Service State
Physical
A code that identifies the generation of the component. Hardware revision codes are
used for tracking components. Hardware Revision
Identifies the manufacturer of the component. Manufacturer
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts. Part Number
A unique serial number that identifies the component. Track IDs are used for tracking
components. Track ID
Flash Firmware
Information about the version of the operational firmware located in the Flash memory of the FCSA.
This firmware is not used in NonStop S-series systems, as system load through an FCSA is not supported on S-series.
The version of the flash firmware running on the FCSA. Version
The name of the file to be used for a firmware update. Default File Name
The version of the firmware to be used for a firmware update. Default File Version
Indication of the differences, if any, between the current and default firmware versions.
Values
Compare State
Flash Boot Firmware
Information about the version of the boot firmware located in the Flash memory of the FCSA.
The version of the boot firmware running on the FCSA. Version
The name of the file to be used for a firmware update. Default File Name
The version of the firmware to be used for a firmware update . Default File Version
Indication of the differences, if any, between the current and default firmware versions.
Values
Compare State
Actions
Flash Boot Firmware Update
Updates the boot firmware in Flash memory of the FCSA. It is not possible to do this update unless the FCSA has a
disk configured through it. If the Flash Boot Firmware Compare State is Unknown, an update attempt will likely fail.
128 System Resources