Enable memory snapshot, Hard reset, Me fpga update – HP NonStop G-Series User Manual
Page 188: Me firmware update, Replace, Set led state, Soft reset
The filename convention is ZM
mmmssn
, where:
mmm
= group number
ss
= module number
n
= version number (incremented for subsequent versions of the same ZM
mmmss
snapshot files)
Example: ZM100023: snapshot file taken of ServerNet Switch Board in group 100, module 02, version number 3.
Enable Memory Snapshot
Creates a snapshot of the ServerNet Switch Board's logic board memory. Perform
to dump this snapshot
to a file in $SYSTEM.ZSERVICE.
Hard Reset
Resets the ServerNet Switch Board hardware and the routing tables.
ME FPGA Update
Allows you to update the FPGA code file for the Maintenance Entity (ME) of the ServerNet Switch Board.
ME Firmware Update
Allows you to update the firmware file for the Maintenance Entity (ME) of the ServerNet Switch Board.
Replace
Launches the guided procedure to replace a ServerNet switch board in an IOAM or processor switch.
Set LED State
Turns the ServerNet Switch Board LED on or off.
Soft Reset
Reinitializes the firmware without affecting the ServerNet Switch Board hardware or the routing tables.
188
System Resources