Fesa (fast ethernet servernet adapter), Attributes, Fesa – HP NonStop G-Series User Manual
Page 132: Physical, Logical, Actions, Abort, Start, Stop, Fesa physical logical
FESA (Fast Ethernet ServerNet Adapter)
An adapter that connects the ServerNet connections inside a server to a 10/100Base-TX local area network (LAN).
The Fast Ethernet ServerNet adapter (FESA) CRU contains one Fast Ethernet ServerNet addressable controller
(
), which contains one Ethernet physical interface, that corresponds to the one Ethernet port on each FESA CRU.
Location in OSM Tree: System > Group > Module > FESA
Slot Location: FESA CRUs can be located in slots 53 and 54 in processor enclosures (service side) or in slots 51, 52,
53, and 54 in IOMF or IOMF2 enclosures (service side).
Example: FESA $ZZLAN.FESA1 (1.1.53)
Attributes
FESA
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Service State
Physical
A code that identifies the generation of the component. Hardware revision codes are
used for tracking components.
Hardware Revision
Identifies the manufacturer of the component.
Manufacturer
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts.
Part Number
Whether the component is powered on.
Power State
A unique serial number that identifies the component. Track IDs are used for tracking
components.
Track ID
Logical
The configuration type of this resource.
Values: CCSA, E4SA, FESA, G4SA, GESA, TRSA, Unknown
Configured Type
The state of the component as known to the operating system on the server.
Device State
Actions
Abort
Terminates operation of the Fast Ethernet ServerNet adapter (FESA) and the associated Ethernet ServerNet addressable
controller (SAC). When the Abort action finishes, the FESA and the SAC are in the Stopped state.
Start
Starts the Fast Ethernet ServerNet adapter (FESA) and the associated Ethernet ServerNet addressable controller
(SAC). The FESA and the SAC must be in the Stopped state before you perform this action.
During startup, the controller operational code is automatically loaded into the SAC. When the Start action completes,
both the FESA and the SAC are in the Started state.
Stop
Rather than automatically stopping the FESA (as the Abort action does), this action first warns you if the FESA is
currently in use (and stops it only after you confirm).
132
System Resources