HP NonStop G-Series - Manual (Page 223)

Common Attribute Values
Battery Charge Status
Meaning Value
The battery is not installed. Absent
The battery is fully charged Charged
The battery is in the process of being charged. Charging
The battery cannot supply power and cannot be charged, possibly because the Disable Battery action
has been performed. You should disable a battery before removal. Disabled
The battery needs recharging or replacement. Discharged
The system is currently drawing power from the battery. Discharging
The battery can accept a charge and is ready to supply power if the AC power is unavailable. Enabled
Check the battery for alarms. If the condition persists, contact your service provider. Fault
The battery is not responding, and its state cannot be determined. Unknown
Compare State
Meaning Value
Current and default versions are the same. Same
The current version is newer than the default version. Up-rev
The default version is newer than the current version. Down-rev
Unable to compare files. Unknown
Device State
Meaning Value
Processing is terminating. Aborting
The device is currently not powered by either AC or UPS. AC Power Loss
State is defined by the NonStop OS. Defined
Performance is degraded. Degraded
A diagnostic test is running on the component. Diagnose
Processing is starting up. Initializing
State is not available to OSM. Not Available
The component is not configured. Not Configured
The component is not installed. Not Installed
Component is accessible. OK
The device is powered on On
The component is running. Started
Processing is starting up. Starting
Processing has been terminated. Stopped
Processing is being terminated. Stopping
Component is not responding. Unknown
Common Attribute Values 223