Swan path, Attributes, Path $zzwan – HP NonStop G-Series User Manual
Page 204: Logical, Actions, Start, Stop, Verify logical configuration, Path $zzwan logical, Start stop verify logical configuration
SWAN Path
A subcomponent of
s and SWAN 2 CLIPs. Every CLIP has two paths, path A and path B. These paths
represent the two Ethernet interfaces on the SWAN concentrator.
Location in OSM Tree: System > SWAN Collection > SWAN > CLIP > Path
Example: PATH $ZZWAN.#SWAN2.1.B
Attributes
PATH $ZZWAN
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Service State
Logical
The media access control (MAC) address of the SWAN Path.
MAC Address
The IP address configured for the SWAN Path.
IP Address
The state of the SWAN Path as known to the operating system.
Values: Started, Stopped
Path State
Actions
Start
Starts the SWAN Path. When the Start action completes, the SWAN Path is in the Started state.
Stop
Terminates operation of the SWAN Path. When the Stop action completes, the SWAN Path is in the Stopped state.
Verify Logical Configuration
Verifies that the SWAN Path is properly configured. If not, an Incorrect Logical Configuration alarm is generated on
the SWAN Path.
204
System Resources