HP NonStop G-Series - Manual (Page 124)

FC-AL I/O Module
Subcomponent of a FCDM .
There are two FC-AL I/O modules in each FCDM. These modules are the interface between the FCDM elements and
the host controller. They route data to and from the drives using loop A and loop B.
Location in OSM Tree: System > Group > FCDM Collection > FCDM > FC-AL I/O Module
Example: FC-AL I/O Module (111.211.1.93)
Attributes
FC-AL I/O Module
Displayed in the Attributes tab and Attributes dialog box only if the value is something other than
OK.
Values
Service State
Physical
Indicates whether or not the FC-AL I/O Module’s (amber) fault LED is blinking.
Value: Blinking or Off LED State
The vendor hardware type. Type
Logical
The state of the component as known to the operating system on the server. Values Device State
A code that identifies the generation of the component provided by its supplier. Vendor Hardware Revision
Device Connection
The location of the configured FCSA connected to the FC-AL I/O Module.
Example: FCSA.FSAC-1.GRP-111.MOD-2.SLOT-1 Configured Controller Location
The number that identifies the FCSA FSAC connected to the FC-AL I/O Module.
Example: FCSA FSAC (111.2.1.1) Fibre Channel Controller
Actions
Blink LED Off
Turns off the blinking of the FC-AL I/O Module’s (amber) fault LED.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED OFF
Blink LED On
Causes the FC-AL I/O Module’s (amber) fault LED to blink on and off.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED ON
Replace
Displays the procedure for replacing the FC-AL I/O module.
124 System Resources