Enable memory snapshot, Hard reset, Me fpga update – HP NonStop G-Series User Manual
Page 220: Me firmware update, Power cycle, Replace, Set led state, Soft reset, Action, to a file in
mmm
= group number
ss
= module number
n
= version number (incremented for subsequent versions of the same ZM
mmmss
snapshot files)
Example: ZM100023: snapshot file taken of VIO logic board in group 100, module 02, version number 3.
Enable Memory Snapshot
Creates a snapshot of the VIO logic board's memory. Perform
to dump this snapshot to a file in
$SYSTEM.ZSERVICE.
Hard Reset
Resets the VIO logic board hardware and the routing tables.
ME FPGA Update
Allows you to update the FPGA code file for the integrated maintenance entity (IME) of the VIO logic board. The
firmware file for IME FPGA (SAM0789) is different from that of other MEs.
NOTE:
Because the hard reset required to complete an FPGA update disrupts a ServerNet fabric, you should perform
a Check Storage Dependence on ServerNet Fabric action (on the
object) to make sure it is safe before
proceeding with the FPGA update. Then update the VIO logic board on one fabric and wait at least 5 minutes after
completion before checking storage dependence and updating the VIO logic board on the other fabric.
ME Firmware Update
Allows you to update the firmware file for the integrated maintenance entity (IME) of the VIO logic board. The firmware
file for an IME (M1805) is different from that of other MEs.
Power Cycle
Power cycles the VIO logic board.
NOTE:
This action is not valid in an S-series VIO Module.
Replace
Displays a service procedure describing how to replace a VIO logic board.
Set LED State
Turns the VIO logic board LED on or off.
Soft Reset
Reinitializes the firmware without affecting the VIO logic board hardware or the routing tables.
220
System Resources