HP NonStop G-Series - Manual (Page 113)

Process Pair
The 2 processors in which this I/O process is configured to run.
Example: 0,1 Configured Processors
The state of the primary I/O process.
Values: Running, Stopped Primary Execution State
The process ID of the primary I/O process. If the state of the primary I/O process is
Stopped, this ID is not displayed.
Example: 1,296 Primary Process ID
The state of the backup I/O process.
Values: Running, Stopped Backup Execution State
The process ID of the backup I/O process. If the state of the backup I/O process is
Stopped, this ID is not displayed.
Example: 1,285 Backup Process ID
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a Hard Down state.
You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of all paths for the disk. When the Abort action finishes, the paths are in a Hard Down state.
You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in the Stopped state.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk was in a STOPPED
state, substate HARDDOWN; a hardware error has occurred; the disk was stopped with an ABORT command; or a
STOP or ABORT fails to put the disk into the STOPPED state, substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in the started State.
Start Disk
Starts all paths to this disk drive. When the Start action completes, all paths are in the Started state.
Start Primary Path
Starts the primary path to this disk drive. When the Start action completes, the primary path is in the Started state.
Start Volume
Starts all paths for both the primary and mirror drives of this volume.
ESS Disk 113