Teledyne LeCroy Merlin II - Users Manual - Manual (Page 87)

77
Merlin II Protocol Analyzer User’s Manual CATC SW Version 2.50
Note If the "sync" light on the front of Merlin II does not change from
flashing to solid it means that Merlin II did not synchronize with the
piconet when it was established.
Loss of Sync Timeout (1-30 secs)
This value specifies the amount of time that Merlin II will wait for piconet
traffic before determining that synchronization has been lost.
Force Re-synchronization
"Force Re-Synchronization" forces Merlin II to re-synchronize at the
beginning of each "Sync & Record," "Passive Sync & Record," or "Sync &
Record" operation. By default, "Force Re-Synchronization" is disabled
(i.e., unchecked).
Unchecking the "Force Re-Synchronization" checkbox tells Merlin II to use
its existing data on Bluetooth devices, thereby bypassing the
synchronization process and saving a few seconds from the beginning of the
trace. If you know that Merlin II’s data is correct, you can uncheck this
checkbox and cause Merlin II to try to use the existing data. If the data is
incomplete or incorrect, however, Merlin II will automatically perform a
refresh.
To examine Merlin II’s Bluetooth data, open the Device List (View >
Device List).
Show Paging Traffic
Show Paging Traffic causes Merlin II to capture paging traffic between the
Master and Page Target devices. This option is used only with Page Sync
and Record Mode.
Follow Anonymity
Allows Merlin II to follow devices that are using anonymity mode.
Anonymity mode is an addressing mode in which devices are assigned
Bluetooth addresses based on a pseudo-random value. Anonymity mode is
defined in the Bluetooth 1.2 specification.