Teledyne LeCroy Merlin II - Users Manual - Manual (Page 75)

65
Merlin II Protocol Analyzer User’s Manual CATC SW Version 2.50
6. Recording Options
While the Recording Wizard provides a "walk through" process for setting
the recording options, you can get a more detailed view and set more
parameters through the "Recording Options" dialog box. The Recording
Options dialog box presents all of the settings needed to make a recording.
Once you have selected your recording options, you then select the
recording mode by clicking the down-arrow on the Record button and
selecting from the two mode options: Piconet and Inquiry. Merlin II will
then use the relevant Recording Options for the selected mode. For
example, if you select Piconet recording mode, Merlin II will use the
options from the Piconet page in the Recording Options dialog box.
6.1 Recording Modes
Pressing the down-arrow on the Record button displays a menu with two
Recording Modes:
Selecting one of these modes tells the analyzer what sets of Recording
Options it should use when you begin a recording.
Note: Selecting a Recording Mode from the menu does not cause the
analyzer to begin recording. To begin recording, you must press the
Recording button itself.
Piconet recording
Selecting Piconet, configures Merlin II to record piconet traffic using the
parameters set in the Piconet page in the Recording Options dialog box.
When you begin recording in this mode, Merlin II will to try to synchronize
to a piconet that matches the Piconet parameters set in the Recording
Options. The recorded traffic is captured off-the-air.
Inquiry recording
This mode configures Merlin II to record Inquiry traffic. When setting the
Merlin II to Inquiry recording, the system is ready to perform a Bluetooth
'General' or 'Dedicated' inquiry, according to the parameters specified in the
'inquiry' page of the Recording Options. The recorded traffic would consist
the transmitted packets as well as the responses received from Bluetooth
devices in the area.