Teledyne LeCroy Merlin II - Users Manual - Manual (Page 139)

129
Merlin II Protocol Analyzer User’s Manual CATC SW Version 2.50
10. Decoding Protocols
10.1 Introduction
Merlin II can decode HCI, LMP and L2CAP messages, and RFCOMM,
SDP, TCS, HDLC, PPP, OBEX, HCRP, BNEP, HID, IP, TCP, and UDP
protocols. The default is packet level decoding, which means that baseband
packets will be displayed when you first view a trace. If these packets are
carrying LMP, L2CAP or other protocols, the protocols will display as
undecoded fields such as the L2CAP packet below.
By issuing a decode command, Merlin II can decode these LMP and higher
fields and display the data in summary statements called LMP/L2CAP
Messages, Protocols Messages, and Protocol Transactions.
10.2 LMP and L2CAP Messages
LMP and L2CAP Messages are lines in a trace that summarize LMP and
L2CAP actions such as an LMP connection request. LMP and L2CAP
Messages summarize the type of action, the number of packets involved in
the action, and the device performing the action. If the message is carrying
higher protocol data such as RFCOMM, TCS, OBEX or SDP data, the
message displays this data in an undecoded format that can be decoded later.
Undecoded L2CAP fields
Undecoded higher protocol data