Teledyne LeCroy Merlin II - Users Manual - Manual (Page 20)

10
Merlin II Protocol Analyzer User’s Manual CATC SW Version 2.50
Power connector for external power supply
This connectors is used to attach the external power supply or for
connecting the analyzer with the provided PS/2 cable from a mouse or
keyboard serial port on the PC or laptop. The PS/2 cable is a pass-through
type that allows you to connect the cable to the PC and then plug the mouse
or keyboard into the back of the PS/2 cable.
2.4 Setting Up the Analyzer
To set up a Merlin II system,
Step 1
Attach the Antenna to the ANT connection point on the analyzer.
The antenna should point up.
Step 2 Connect the provided external power supply to the analyzer and then
to a 100-volt to 240-volt, 50 Hz to 60 Hz, 100 W power outlet.
Alternatively, you can connect the PS/2 cable into the analyzer and
one of your PS/2 ports (i.e. keyboard or mouse ports). The keyboard
or mouse would then plug into the back of the PS/2 cable.
Note At power-on, the analyzer initializes itself in approximately ten seconds and
performs an exhaustive self-diagnostic that lasts about five seconds. The status
LED flashes during the power-on testing and turns on steadily if the unit is
functioning properly when testing is finished. If the diagnostics fail, the status
LED blinks slowly, indicating a hardware failure. If this occurs, call CATC
Customer Support for assistance.
Step 3
Connect the USB cable between the USB port on the back of the
analyzer and a USB port on the analyzing PC.
The host operating system detects the analyzer and begins to install the USB
driver.
2.5 Installing the Analyzer Software on the PC
Once Merlin II has been recognized as a USB device, install the Merlin II
software on the PC administering the analyzer.
Step 1 Insert the Merlin II Suite CD into the CD ROM drive of the
PC that will be administering the Analyzer.
Step 2 Follow Windows on-screen Plug-and-Play instructions for the
automatic installation of the Merlin II Analyzer as a USB device on
your analyzing PC (the required USB files are included on the
Merlin II CD.