Telos Zephyr Xstream - Manual (Page 86)

USER’S MANUAL
Section 4: BASIC OPERATION & INSTALLATION 74
4. Press < 5> then <SEL> to reboot.
The illustration below shows several sample Location Setups. Note that the notation “A” in the
right column indicates that a particular setup includes AUDIO menu settings as well as TEL menu
settings.
Creating Location Setups – Set by Step
1. Configure the Zephyr Xstream with the ISDN line to be used at this location
(see below). You must make certain that the menu selections in the TEL and
AUDIO (optional) menus are set correctly:
• All menu settings in the TEL menu. Ideally, you should be connected to
the line for the target location, so you can verify the ISDN settings are
correct. In that case, the line status should indicate Ready & Ready
(with ETS 300 ISDN it is acceptable if Deactivated & Deactivated is
displayed). If you are not connected to the line that's ok too, but you
should be certain that the menu selections in the TEL menu are set
correctly. NOTE: TEL menu settings are always included in a Location
Setup.
h
HOT TIP!
You can activate an existing setup to recall these parameters, assuming you have an existing
setup for the line in question. Do this first, and then make the necessary changes to the
AUDIO menu settings. Then create your new LOCATION setup as described below.
• If you wish to include AUDIO settings in this Location Setup (optional):
• All menu settings in the AUDIO menu.
• And: Front panel Main mixer A/B buss assignments (MX/MXP only)
• And: Front panel Snd/Rcv settings for Local Mix 1 & 2 (MX/MXP
only)