Telos Zephyr Xstream - Manual (Page 253)

USER’S MANUAL
Section 11: THE WORKS – Detailed Menu Reference 241
The DROP menu
The Drop menu is activated by pressing the <DROP> button once. It looks like this:
The system will default to Line 1 if that line is in use. It will default to Line 2 only if Line 1 is not
in use. Press <DROP> a second time to drop the line shown.
To drop a Line other than the line shown, press the <SEL> button, then press <
5> or <6> to
select the desired Line(s). To drop the Line(s) press <DROP> again.
To easily clear both ISDN lines simply press <DROP> four times.
The AUTO menu
The AUTO menu is used to enter or activate Dial Setups and Location Setups.
Dial Setups
Dial Setups are very similar to the "Auto Dial Setups" used in the classic Zephyr. Each of the 100
dial setups consists of several pieces of information. See Section 4 (Basic Operation and
Installation) for information on creating and using Setups.
• A Setup number – this 2 digit number (00 to 99) can be used to instantly
access a given setup.
• An alphanumeric Name
• Number 1 (optional) – A telephone number to be dialed on “Line 1”
• A “mode” for number 1 – Either Zephyr for a codec call, Xport for a call to a
Zephyr Xport using a POTS line, or Phone for calls to a standard telephone.
• Number 2 (optional) – A telephone number to be dialed on “Line 2”
• A “mode” for number 2
• Include selection. This allows you to include CODEC menu settings
(optional) – This is a snapshot of all settings of the CODEC menu. This allows
the unit to automatically change to the settings used with a given site based
on the Dial Setup used.
Connected
Connected