Telos Zephyr Xstream User Manual
Page 262
USER’S MANUAL
Section 12: System Functions and Remote Control 250
Description: Select analog/AESEBU input level in dB.
Name.......: zlog
Parameter..: [SYS|ISDN|IMON|SEXT|TIME|ITIM]
Group......: Zephyr-style
Description: Switch on a combination of logging channels. No parameter will switch off
logging.
Name.......: zloop
Parameter..:
Group......: Zephyr-style
Description: Loop mode far, near or off, Default off
Name.......: znetwork
Parameter..:
Group......: Zephyr-style
Description: Select network: ISDN, ethernet or V.35
Name.......: zreset
Parameter..: -
Group......: Zephyr-style
Description: Reset Zephyr (warm boot).
Name.......: zrxmode
Parameter..:
Group......: Zephyr-style
Description: Select receive mode L3-mono, L3-stereo, G.722, Layer2 stereo, Layer2 24kHz,
Layer2 mono, default: L3ST)
Name.......: zsetup
Parameter..: [<1..50>[<-|name
Group......: Zephyr-style
Description: Display or define setup.
Name.......: zspids
Parameter..:
Group......: Zephyr-style
Description: Set or delete SPID number.
Name.......: zstat
Parameter..: -
Group......: Zephyr-style
Description: Zephyr Remote Stat information ...
Name.......: ztelco
Parameter..:
Group......: Zephyr-style
Description: Select ISDN switch type.
Name.......: ztxmode
Parameter..:
Group......: Zephyr-style
Description: Select transmit mode. Layer3: dual mono, stereo, joint stereo, G.722, Layer2:
mono, mono 128/112kbps, dual stereo, joint stereo, mono 24kHz. Default: L3DU)
Name.......: zver
Parameter..: -
Group......: Zephyr-style
Description: Display version information.
Name.......: ethermode
Parameter..: [
Group......: Stream Decoder Description: Set the l3/aac streaming
Name.......: dcclient
Parameter..: [
Clients