Telos Zephyr Xstream - Manual (Page 254)

USER’S MANUAL
Section 11: THE WORKS – Detailed Menu Reference 242
h
HOT TIP!
If you are using one of the Xstream's V.35 interface modes (see Section 9)you can use Dial
Setups without phone numbers to conveniently changes modes.
If a setup containing a phone number is activated while the Interface (in the third TEL menu)
is set to V.35 Split, or V.35 single, the system will change the interface to ISDN so that the
number(s) may be dialed.
Z
ZEPHYR CLASSIC VS XSTREAM COMPARISON
The Zephyr Xstream’s Dial Setups offer some important differences from the Zephyr’s Auto
Dial Setups:
4. Inclusion of codec information is optional with the Xstream, whereas it is
mandatory with the Zephyr. Inclusion of codec information is the default.
5. Xstream allows independent setups for Line 1 and Line 2 to be used. Zephyr
does not allow access to Auto Dials if any line is in use.
6. Zephyr only allows Auto Dial Setups to place data (i.e. Zephyr) calls while
Zephyr Xstream’s Mode settings allow Dial Setups to place calls to an Xport
using "Xport" Mode and a regular telephone using the “Phone” Mode.
h
HOT TIP!
You can use dial setups as a way to conveniently change your codec settings. Possibly to
accommodate incoming calls from differing locations.
Simple leave the Number 1 & Number 2 field blank, and set Include to Codec. As always, be
sure to set the CODEC menu items to the proper settings before creating your setup.
Location Setups
Location setups are a useful feature that allows you to pre‐configure information about the ISDN
line (TEL menu information) and the mixer setup/assignment information (AUDIO menu and
MX/MXP front panel information) for frequently visited locations. Each dial setup consists of
several pieces of information:
• A Setup number – this three‐digit number can be used to instantly access a
given location setup.
• An alphanumeric Name
• TEL menu settings – This is a snapshot of all settings of the TEL menu.
• AUDIO settings (optional) – This is a snapshot of all settings of the AUDIO
menu. Note, the front panel Left/Right and Snd/Rcv mixer assignments on
the Zephyr Xstream MX/MXP model’s front panel are included along with
the settings in the AUDIO menu.